Sentry Safe model # SFW082F
5 posts
• Page 1 of 1
Im trying to figure out how you hot wire the wires on this safe to open the door. It doesn't have a key hole just a key pad. Must be a way to connect wires to activate the release of the pin in order to open the door?? I do not want to use a magnet I want to spike or put power to the actuator but not sure what wires to use. HELP??
Last edited by barrysmith110 on Wed Feb 23, 2022 2:56 pm, edited 2 times in total.
Keeper of the Bests / Supreme Overlord of Small Format Interchangeable Picking Nightmares
Posts: 2165
Joined: Sun Jul 24, 2011 11:16 am
Location: Canada
Re: Sentry Safe model # 8FW082F
Welcome to the forum. I have moved your post to the correct area. You will not receive an answer to your question given the nature of the question and you being a new member.
PhoneMan: I always knew I'd say something stupid and it would be someone's sig
macgng: i am an equal opportunity pervert
macgng: aww fuck thats goin in someone sig :-(
If life gives you melons, you might be dyslexic.
macgng: i am an equal opportunity pervert
macgng: aww fuck thats goin in someone sig :-(
If life gives you melons, you might be dyslexic.
Re: Sentry Safe model # 8FW082F
Thank you
Re: Sentry Safe model # 8FW082F
barrysmith110 wrote:Im trying to figure out how you hot wire the wires on this safe to open the door. It doesn't have a key hole just a key pad. Must be a way to connect wires to activate the release of the pin in order to open the door?? HELP??
I believe the model # is SFW, not 8FW. Even so, Riyame is correct about not getting the answer you seek on this forum.
...Warm smell of colitas, rising up through the air... Eagles, Hotel California, 1976
Re: Sentry Safe model # SFW082F
Your answers are on YouTube. You do not 'hotwire' them.
5 posts
• Page 1 of 1
Return to Safes, Strongboxes & Combination Locks
Who is online
Users browsing this forum: No registered users