Newb needing guidance
I have a Big Red mounted cut away from MBA.
I set the combo to 7-28-60.
I printed a vernier on sticky paper and put it on the outer ring and found it really quick and easy to use.
I ran in increments of 2 then amplified the 2 gate areas found to 1.
The wheel runs freely and the contact points are really easy to determine.
My first graph I picked up a large drop in contact area centered at 60-1/2 and a slightly lesser one at 27-1/2.
They both look like gates to me based on following several threads here.
I did a high test with 60-1/2 and W3 had a 0.8 and 0.5 wider contact area than W1 and W2 respectively so W3 60-1/2.
Textbook at that point to me so I was really pleased.
However I parked W3 at 60-1/2 and ran a high and low test for 27-1/2 on W1 & W2 and the high test was just 0.1 differential and the low test even.
I ran them again watching to make sure I had the wheels set correctly gave the same results.
Given that I know W2 is 28 the 0.1 differential is incorrect.
I ran a second graph from 0 to 32 with W3 parked on 60-1/2 and picked up the gate at 27-1/2 but did not pick up the gate at 7.
What would be the proper thing to do at this point?
Test combos?
Some dialing test I am not aware of?