From the last couple of nights. L to R
Medeco Biaxial KIK - MLAA JB Profile 6 Pin - Yale 6 Pin - ASSA 600/700?
The ASSA Im quite proud of, as after I got it, I picked it easily and when I opened it up I found a whole lot of masters. Wizer sent me some blanks to suit (I had to shave them a little), and so I repinned it with the nastiest bitting I could come up with. Also, I filled it with a mix of 2 and 3 serration, and normal drivers, which worked really really well to foil me, and had me oversetting a lot of pins. MACs be damned, take a close look at the key and try to decipher all 7 cuts! Again, this is another that I would love to get a model on, I believe its a 6 or 700? 7 pins, all standard drivers orignally, but this could have been because of the master system. Another Medeco as well, Im trying to pick 1 or 2 a week to really get a handle on them. I picked CW and set the pins normally, raked them for rotation to put them into any gate, and then used the DCAP lifter to move them into the true gates.
FUN FACT! As you can see above, the profile of the JB spells out 'ML' for the Master Locksmiths Assoc of Aust, who commissioned and sold them. This is the case with the entire 'J' series, including JA, JB, JC, JD, JL & JM, and also the preceeding ML1 profile. If anyone out there has an ML1 with key, like the on in
this thread over at LP101, and would like to trade, please PM me, I would love to obtain one.
adi_picker