Pull type impressioning tools

[MrWizard]

I have seen this tool before in the small MBA catalogs they send me in the mail. Can you tell us what the second knob on the side behind the knob that clamps the blank is for. Also see what looks like 2 more on the bottom side curious what they are for also. The adjustable LED light is a great addition looks nice. Is it attached with hardware or a magnet for easy removal?

Richard

[oldlock]

The front screw on the keyclamp sets the thickness, the rear know pivots the clamp to hold the key without over tightening.

The two screws below set the start and stop points of the thrust pin / trigger travel. This prevents the key being pulled too far.

The light is mechanically affixed, it can slide forwards and backwards or be removed at will without tools.

[MrWizard]

Great all those feature are very nice to have, makes the Grumbach tool look prehistoric in comparison.

Thanks for the information too bad the price is so far from reason I would give it try.

Richard