Homebrew key holder for impressioning???
Anyone have one they made themselves? I know Jos Weyers has one but I have no idea how it's built.
Random wrote: Here is my tip of the day "Do not fart while wearing overalls".
MBI wrote:I think the kit only cost me about $8 but that's been 3 or 4 years I think, so might be a bit higher now.
OldddffAASSTT the Spin Master Extraordinaire and American Lock Slayer
Posts: 4412
Joined: Thu Mar 31, 2011 9:16 am
Location: Michigan
Oldfast wrote:On a side-note: If anyone's interested in upgrading from their vice grips... this has served me well for over a year now.
This is an auto tool used for removing the seal around car windshields. Stripped of its' addtional parts, the handle works
beautifully for a key holder. This idea is not original to me. I first seen it in a vid from Daz (of DBC locksmiths). Check the
local auto places in your area (Napa, Auto Zone, Advanced Auto, etc.). Daz paid around $12 for his. I think I paid about $19
LockButcher wrote:MBI wrote:I think the kit only cost me about $8 but that's been 3 or 4 years I think, so might be a bit higher now.
Ooooh man inflation got it up to $16 now haha.
MBI wrote:LockButcher wrote:MBI wrote:I think the kit only cost me about $8 but that's been 3 or 4 years I think, so might be a bit higher now.
Ooooh man inflation got it up to $16 now haha.
Sorry if I misled anyone on the price. The more I think about it, it must have been closer to 5, 6... maybe even 7 years ago when I bought it. Which probably explains the inflation a bit better. Aluminum prices were a lot lower then. Gas too.
Return to Pin Tumbler Impressioning
Users browsing this forum: No registered users