Page 1 of 1

Riyames LaGard Grp 2 Lock Just got a FaceLift

PostPosted: Thu Dec 29, 2011 9:03 pm
by MrPharmer2012
I purchased this lock from Riyame and would like to put it on a different board to work with it and can not figure out how to get it apart. does anyone have an owners manual or service manual or advice on how to do this any info will help out thanks.
Thanks
Corey S

Thank You Riyame for the lock and thank You MDChurchill for the information.

Stand is now painted with textured stone finish and lock installed.
now all I need is some freetime to learn manipulation.

Re: How to Remove/Breakdown Lagard Group 2 Safe Lock

PostPosted: Thu Dec 29, 2011 9:15 pm
by mdc5150
LAGARD 3 WHEEL-Changing.pdf

3370 INSTRUCTIONS.pdf


I wish I had more but this is it.

You will probably want more help than I can give you here, but basically your dial is on a spline. The spline is like the axle to the wheel. At the opposite end of the dial is a spline key. The spline key locks the spline into the wheel pack. When you tkae the spline key out you can unscrew the spline from the wheel pack and take the lock off of the board. When you do this be VERY careful to keep everything where it is inside the lock.

Re: How to Remove/Breakdown Lagard Group 2 Safe Lock

PostPosted: Thu Dec 29, 2011 9:29 pm
by MrPharmer2012
mdchurchill wrote:
LAGARD 3 WHEEL-Changing.pdf

3370 INSTRUCTIONS.pdf


I wish I had more but this is it.

You will probably want more help than I can give you here, but basically your dial is on a spline. The spline is like the axle to the wheel. At the opposite end of the dial is a spline key. The spline key locks the spline into the wheel pack. When you tkae the spline key out you can unscrew the spline from the wheel pack and take the lock off of the board. When you do this be VERY careful to keep everything where it is inside the lock.


Thank You I pulled it out and unscrewed it.

Re: How to Remove/Breakdown Lagard Group 2 Safe Lock

PostPosted: Thu Dec 29, 2011 9:36 pm
by mdc5150
Excellent, glad I could help.