Combo not working
I searched and found this in Reddit:
Well now for the money shot. Pull the sticker off the center of the dial. Set the dial at 0, put a mark on the safe just next to the dial at the number xxx.. Unscrew that screw, pull the dial up and off. Measure from the center of the screw hole in the direction of the mark you made at xx, exactly x inch. Put a dot there. That is where you should drill a xx" hole. Drill into the door, approximately xx" with a standard high speed drill bit. You will feel the bit enter an air space....STOP. Get a good flash light, look into the hole and turn the post that held the dial. What you are looking for is to line the gates of the wheels up with that piece of white metal you also see in the hole. Once the two gates are aligned, turn the spindle right, the fence will fall into the gates and will retract the two locking bolts. Good luck..and ask questions if you have them.
Which seems fairly do-able, but I need some elaboration (particularly on the Xs) and would really just like to find a way to use the code (already tried +3/-3)
Ideas?