Lagard Smartgard v.5.0 6260 002D-00 (hi-sec electronic lock)
19 posts
• Page 2 of 2 • 1, 2
If your clips are too small to hook to the eeprom you can solder some small wires to it and run those to larger pin headers. Assuming your soldering iron is small enough to work on a part that size.
Re: Lagard Smartgard v.5.0 6260 002D-00 (hi-sec electronic l
Information about the reset box: viewtopic.php?f=100&t=13210
In case you wonder ... Martin Hewitt is a fictional detective in stories by Arthur Morrison:
Martin Hewitt, Investigator Chronicles of Martin Hewitt
Martin Hewitt, Investigator Chronicles of Martin Hewitt
Re: Lagard Smartgard v.5.0 6260 002D-00 (hi-sec electronic l
Actually I had built the reset box (viewtopic.php?f=100&t=13210) and tried on it just before your post. I'll make a video to show. I have two of these locks, so I only tried the reset box on one of them and... it doesn't accept any code, some seconds after inserting any code it shows "error 256 serial", i think I have screwed it up...
The second lock, don't ask me how, only trying some codes, I got to change the master code and access master menu, but I also need to have at least the manager code to add an user to set a code to finally open the lock. I will also make a video showing this.
The second lock, don't ask me how, only trying some codes, I got to change the master code and access master menu, but I also need to have at least the manager code to add an user to set a code to finally open the lock. I will also make a video showing this.
Re: Lagard Smartgard v.5.0 6260 002D-00 (hi-sec electronic l
I've found a reset software, but I need the interface cable (ref: 2034), does anyone know the pinage to link the "four way" connector of the lock onto a usb? actually the cable is serial, but, knowing the pinage, make an usb version don't seems to be a problem.
19 posts
• Page 2 of 2 • 1, 2
Return to Safes, Strongboxes & Combination Locks
Who is online
Users browsing this forum: No registered users