Douggie's Home Brew Thread

[Dopug]

Ok I will be compiling all my home brew stuff into this thread so I don't start cluttering up the forum.

The first thing I'm uploading for you guys is a set of pick profiles I've been working on today.

I carefully measured my favorite hook with a vernier gauge and based the designs around that, the curves are my own design but are based on falle-safe.

I used Corel Draw to produce the designs and have put a mm scale down the side so you can check there the right size if you print them out.

I'll be purchasing so shim stock this week and will get to work on making some picks ASAP, but feel free to use the designs to make your own.

The curves were a bugger to create but I'm pretty pleased with the results, let me know what you think



here's a negative

[Dopug]

Here's the set of curves I will be making as they will fit in my tool roll.



On the original image's i posted here i had asked for credit from anyone using these patterns, after talking with some people in chatg it seems that some felt this was not fair as the designs are basiclly the same a falle's and sparrows. this i know but the profiles are my own and i spent many mnay hours creating these in corel draw. I wasn't asking for credit for the designs themselves, just the time taken in creating the patterns. anyways just thought i'd clear that up.

these are all just jpgs so the quality is not so good. if anyone would like a high quality and correct size PDF just pm me and i'll send you one