My New Pick Handle!!

[KokomoLock]

Ok, decided to make a pick handle that could be used over and over and over. What I did was took a piece of round steel stock and cut a slit down the middle with a hack saw. I put a little curve in it in hopes it would hold the pick in a little better. Then insert your favorite pick into the slot. I then took a small plug follower which fits tight over the steel rod and tap it into place. Done, now when I bend or break the pick just slide the sleeve off, replace the pick and sleeve and do it all over again. Here are some pictures!!! Version 2 will be done in all brass!!!

[chris]

that's pretty damn good thinking. how's the handle feel while holding? good feedback?

[LocksmithArmy]

when you fall in love with version 2... ill take version 1 off ur hands

very creative man nice work

[KokomoLock]

that's pretty damn good thinking. how's the handle feel while holding? good feedback?

Thanks! It is comfortable, about like holding a Sharpie Marker. The feedback is great, all metal, no adhesive. It is a little heavy but that is how I like em, I could always cut some off the end if it was to heavy. It even picks high security locks without even thinking about it!!!!!

[LocksmithArmy]

It even picks high security locks without even thinking about it!!!!!

that is high security

and that is one shiny peterson man...

[the lockpickkid]

Yep! I bet it won't open one of those high security Master # 3's though. But you can try!

[Solomon]

That's really neat, I like it a lot!! Simple solutions like this are the best, good job koko

[kamikaze]

That is a Great looking Handle Kokomolock!