First Time Manipulation
This was not an easy task.
There were some moments of doubt and frustration, but I stayed with it. I made several graphs, noting both LCP and RCP. I also tried some shortcuts when frustration started kicking in-not recommended. In the end, I had located one number (W3 after high/low testing) and was on my to finding the other two. I decided to (once again) carefully graph W1&2 with W3 parked on its gate using RCP only, paying particular attention to maintaining the same “feel” when locating the contact point. When finished with the graph, I could clearly see two gates…I was going to open the safe! After a short period of trial and error, I was rewarded by a solid “click” and an open safe! It happened so quickly, I almost didn’t realize what I had just done!
Overall, the manipulation was a fantastic learning experience. It was so much fun to learn something that I never really understood before. Looking back, I can identify my errors (there were many!) and also identify things I did correctly. I think the most important things (for me) were keeping the same pressure on the wheel (easier said than done) when locating contact points and also graphing accurately. Another resource pointed out a very logical way of graphing. It turned out to be a tremendous aid when producing my final graph.
Anyway, that’s my lock manipulation story. I’m sure many of you would have had the safe open in minutes (it took me about 8 hours over the period of a few weeks), but I thought you might enjoy reading another story of a first time manipulation. So exhilirating! Thanks again to LockManipulator for creating such a great guide and also to Oldfast for his beautifully detailed chronicles. Also, thanks to Kerti for identifying the correction for high/low testing. I was scratching my head on that one for a while before I saw your post. Without those resources, I’m not sure this would have been possible.