Re: Code cutting question
It will have to be done or set manually - shoulder -tip & the machine your using makes a big difference !!!
Example Toyota 8 cut and 10 cut - look to be tip cut at the same point using the blitz 1200 hpc
but are not as the 10 cut key is at least 0.030 over - not flush to vice
The framon again - tip stopped equally - manually set but framons code cut starts from head - a lot to think about
look forward to seeing it finished - much easier to copy a key than code cut if you don't have the experience
even the blanks used - should be checked and can differ
ringo
Example Toyota 8 cut and 10 cut - look to be tip cut at the same point using the blitz 1200 hpc
but are not as the 10 cut key is at least 0.030 over - not flush to vice
The framon again - tip stopped equally - manually set but framons code cut starts from head - a lot to think about
look forward to seeing it finished - much easier to copy a key than code cut if you don't have the experience
even the blanks used - should be checked and can differ
ringo