I need pics of the wireing of an HPC1200
7 posts
• Page 1 of 1
I have an old HPC1200 that had a 12v motor but was missing a lot of the stuff that should have been there. I now have a 120V motor but it came with a circuit board for a feature I dont have. I do not want to install it so I need to know if anyone out there has an HPC1200 that only has the Capacitor in the wiring and if so can you post a pic or send one my way so I can see how it is wired..
Re: I need pics of the wireing of an HPC1200
Never mind... I got it
Re: I need pics of the wireing of an HPC1200
I finally finished with the HPC1200 and got it all dialed in.
Re: I need pics of the wireing of an HPC1200
Wow! the machine is looking great. Glad I could help with the lens.
femurat: They're called restricted for a reason...
Innerpicked: The more keys you carry, the more important you look
GWiens2001: Great video! Learned a lot about what fun can be had with a forklift and a chainsaw.
pmaxey83: but i first have to submit the proper forms for a new hobby to my wife
Innerpicked: The more keys you carry, the more important you look
GWiens2001: Great video! Learned a lot about what fun can be had with a forklift and a chainsaw.
pmaxey83: but i first have to submit the proper forms for a new hobby to my wife
Re: I need pics of the wireing of an HPC1200
Thanks again Jeff... I almost contacted you about checking on other parts but the ones I had worked out ok.
If I can get my hands to stop hurting I will take the RYTAN 100 apart next.
If I can get my hands to stop hurting I will take the RYTAN 100 apart next.
Re: I need pics of the wireing of an HPC1200
I feel so stupid!!!
My memory has been getting bad for the last few years but after getting the HPC1200 completely redone, I finally ordered the Medeco keys I needed for my KIK cylinders. I got the keys today and was very excited because I would finally be able to cut the keys.... I took them out to the garage and realized that not only do I not have the Medeco "C" jaw but I also dont have the 1012 cutter...
Well I guess its time to take them to the locksmith and have them cut the keys (maybe change the bitting while they are at it.)
My memory has been getting bad for the last few years but after getting the HPC1200 completely redone, I finally ordered the Medeco keys I needed for my KIK cylinders. I got the keys today and was very excited because I would finally be able to cut the keys.... I took them out to the garage and realized that not only do I not have the Medeco "C" jaw but I also dont have the 1012 cutter...
Well I guess its time to take them to the locksmith and have them cut the keys (maybe change the bitting while they are at it.)
Re: I need pics of the wireing of an HPC1200
Well, I cut a key using the 90-MC cutter instead of the 1012 and used the normal A jaw instead of the C jaw. I guess the C jaw holds the key farther out because I ran out of adjustment and had to try a couple times to get the right depth of the cuts. They mostly came out close enough except the 1st cut that was a #3 cut RIGHT, I cut that one a little low so the key is not smooth when turning.
Oh well, the key works and I have 4 left to have done right.
Oh well, the key works and I have 4 left to have done right.
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users