Pushed pin out last night
It is .07-.075 thick pin is a little oblong from being pressed thru
The shackle is .5 wide the Chanel the pin rides in is aprox. .07-.09 so I wouldn't make pin longer than .6 but length isn't that big of an issue as long as the pin doesn't stick out to far or not enough it just needs to hold shackle in push in and keep turning shackle till it fits . U take everything out ad place shackle in just till it is below the cross bar on shackle side just to where u can see hole place roll pin in taper one end place a punch or something solid on end of pun and lightly tap in with hammer till fits and turns freely in channel