Master ProSeries 6836 Dissassembly
So I bought a lot of these Master 6836 lockout locks on ebay. I'm trying to disassemble them fully, removing the cam, ball bearings shackle etc. But I couldn't for the life of me figure out how.
I found this on Master's website:
After which I looked into my own lock and sure enough, there's a circlip holding everything in.
I've never seen this type of retention in a padlock before. I can't seem to remove it either. It's a pretty tight space and I can't fit even the most narrow needle noses I have. Any suggestions?
I found this on Master's website:
After which I looked into my own lock and sure enough, there's a circlip holding everything in.
I've never seen this type of retention in a padlock before. I can't seem to remove it either. It's a pretty tight space and I can't fit even the most narrow needle noses I have. Any suggestions?
You do not have the required permissions to view the files attached to this post.