Disassemble Mastercraft lock
4 posts
• Page 1 of 1
I'm disassembling a mastercraft lock and I was wondering what the next step would be.... I don't see a nut inside....
Lord Emeritus of Keypicking HallisChalmers
Posts: 2070
Joined: Mon Apr 28, 2008 2:46 pm
Location: Hell
Re: Disassemble Mastercraft lock
Hmmm....no retaining screw holding the cylinder?
More than likely it is swaged in place. You may have to carefully drill it out, taking out a little bit more of the surrounding metal stock each time. Probably need a drill press.
Is there any kind of cross pin coming in from the side that might also retain the cylinder?
More than likely it is swaged in place. You may have to carefully drill it out, taking out a little bit more of the surrounding metal stock each time. Probably need a drill press.
Is there any kind of cross pin coming in from the side that might also retain the cylinder?
Re: Disassemble Mastercraft lock
drill the rivet,replace with a master 930 bolt...
(that would be my first approach.)
(that would be my first approach.)
Re: Disassemble Mastercraft lock
HallisChalmers wrote:Is there any kind of cross pin coming in from the side that might also retain the cylinder?
HC, There was a cross pin, and PT2 shows it, after I drill....
Part 1- The Drilling
Part 2- The Guts
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users