Page 1 of 1
question about feeler gauge
Posted:
Fri May 04, 2012 12:25 pmby .45cal
My question is has anyone actually used the gauge stock that comes in a roll? When it comes off the roll does it go back to being straight? it seems to me that once it has been rolled like that it will always have a bend.
Re: question about feeler gauge
Posted:
Fri May 04, 2012 1:20 pmby Aedalas
I personally have not used it for picks, but I've used a roll of strip metal at work quite a few times. If it's a few feet long it has a bow to it, but short pieces are pretty flat providing the roll isn't too tight. I think Violaetor uses a coil for picks, not sure if it's feeler guage stock though.
Re: question about feeler gauge
Posted:
Fri May 04, 2012 3:43 pmby Violaetor
I do use a coil, but it is not feeler gauge. Minimal retention from the coil, but can't speak of the feeler stock as they are different compositions and tempers.
Re: question about feeler gauge
Posted:
Fri May 04, 2012 3:50 pmby .45cal
if not feeler stock mind if I ask what you use? pm if you like.
Re: question about feeler gauge
Posted:
Fri May 04, 2012 3:53 pmby mech
ive tried to find a roll of what he uses and i cant find any =[