DIY - Redneck Pinning Tray / Plug Holder
Posted: Thu Mar 15, 2012 9:03 pm
Hey All,
I finally tore apart an old door handle lock.
I've been tinkering with re-pinning and such. So I decided
I needed something better for holding pins and such.
So an idea was born!
Lumpy's Redneck Pinning/Plug Tray Ver. 1.0
This cost me $0.00. 20 Minutes to make.
I took a 5" chunk of 2"x4" and drilled seven 1/4" holes 2" deep into
the side. I then "attempted" to drill two more 1/2" holes about
1.5" in from the other side.
I then chopped it slightly off center with my saw, boxed off the
edges and sanded.
As you can see my 2 side plug areas didn't work as planned. So I
took a drum sander bit to them. I'll perfect this with Ver. 2.0.
Functional.
Enjoy!
I finally tore apart an old door handle lock.
I've been tinkering with re-pinning and such. So I decided
I needed something better for holding pins and such.
So an idea was born!
Lumpy's Redneck Pinning/Plug Tray Ver. 1.0
This cost me $0.00. 20 Minutes to make.
I took a 5" chunk of 2"x4" and drilled seven 1/4" holes 2" deep into
the side. I then "attempted" to drill two more 1/2" holes about
1.5" in from the other side.
I then chopped it slightly off center with my saw, boxed off the
edges and sanded.
As you can see my 2 side plug areas didn't work as planned. So I
took a drum sander bit to them. I'll perfect this with Ver. 2.0.
Functional.
Enjoy!