falle home brew
4 posts
• Page 1 of 1
so i took a spreading knife and cut it in half with a Dremel cut-off wheel then printed out temples from Google. then outlined temples and went to the bench grinder. Here is what came out lol. As you can see the top one (below Peterson) is a little rough on bottom it got caught in grinder when finishing up. overall they turned out pretty good. going to make some kind of handles at some point
You do not have the required permissions to view the files attached to this post.
Professor Emeritus Of Lockpickology and Smithery
Posts: 1107
Joined: Thu May 14, 2009 1:23 pm
Location: Indiana
Re: falle home brew
The one under the Peterson look kinda rough but number 2 under the peterson looks great!!! Homebrew beats ALL!!!!
Re: falle home brew
have not used them much. work good in american 1105 and yeah the top one bends cause it got nicked by grinder. will have to make another one. but that bottom one turned out great. **EDIT** Broke off shitty part and redid the top one here is a picture (is now the bottom one lol) if anyone has some feeler gauge and is willing to donate or trade pm please
You do not have the required permissions to view the files attached to this post.
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users