JimyLongs Cutaways
Posted: Sat Dec 13, 2014 5:30 pm
Nice, JimyLongs. Did you use a mill?
Gordon
.:: Keypicking :: Anything And Everything For Locksmiths, Hobbyist Lock Pickers, Locksport, Lock Picking, lockpicks, cutaways and Security. Simply The Best Lockpicking Forum Around!
A Discussion Forum For Anything And Everything For Locksmiths, Hobbyist Lock Pickers, Locksport, Lock Picking, Lockpicks, cutaways, and security. Simply The Best Lockpicking Forum Around!
http://keypicking.com/
JimyLongs Cutaways
Page 1 of 1
Posted: Sat Dec 13, 2014 5:30 pmRe: JimyLongs Cutaways
Posted: Sat Dec 13, 2014 6:09 pmRe: JimyLongs Cutaways
Posted: Sat Dec 13, 2014 6:34 pmVery nice! I like it!
Re: JimyLongs Cutaways
Posted: Sat Dec 13, 2014 7:11 pmI did use a mill, it was pretty hard metal.
Thanks Oldfast, I was also able to see why your method on manipulating them works. At least for the 1st number. The bottom of the reset piece barely touches the 1st wheel.
Thanks Oldfast, I was also able to see why your method on manipulating them works. At least for the 1st number. The bottom of the reset piece barely touches the 1st wheel.
Re: JimyLongs Cutaways
Posted: Sat Dec 13, 2014 9:34 pmjimylongs wrote:Thanks Oldfast, I was also able to see why your method on manipulating them works.....
Neat! Ya know it's rather ironic after all this time, but.... believe it or not,
I've never had an 'inside view' of my method actually taking place. LOL
Re: JimyLongs Cutaways
Posted: Sun Dec 14, 2014 8:39 amNice job Jim:
I have an old master combo I haven't manipulated yet. Now that I have an idea where to cut I may have to sacrifice it in an attempt to emulate your work. (won't be near as pretty as a I don't have access to the right tools)
I have an old master combo I haven't manipulated yet. Now that I have an idea where to cut I may have to sacrifice it in an attempt to emulate your work. (won't be near as pretty as a I don't have access to the right tools)
Re: JimyLongs Cutaways
Posted: Sun Dec 14, 2014 8:49 amDoogs wrote:Nice job Jim:
I have an old master combo I haven't manipulated yet. Now that I have an idea where to cut I may have to sacrifice it in an attempt to emulate your work. (won't be near as pretty as a I don't have access to the right tools)
Ditto. Appreciate the ideas.
Gordon