Framon 2 abloy adaptor build Disklock Pro / Team Project
How practical do you think this will be and is it achievable as a add on
The ford adapter works well for the tibbe keys ..did a post a few years ago on here But was made by framon
so based off this with complete rotation for the angle Or degree of cut required for the 10 cuts
Possible Abloy adaptor based on the framon tibbe adaptor. https://imgur.com/a/He39Vnn
Mr P would be great for this job anyway any ideas how to please post up . A abloy disklock adapter sounds good
As a few of us have them on forum . it's marketable too if successful
Brain wave or storm it seems plausible ( clamping and rotation ) of blank key And degrees of angle
is it even POSSIBLE...well where about to find a Answer .
Many great minds on Key picking ..let's do this guy's and gals .
PLAN / FORUM PROJECT.
1. Make a Awesome working abloy disklock adaptor cutter .
The Key Disklock Pro
https://i.postimg.cc/Fz5CqhKG/Screensho ... 130558.jpg
Question 1.
How big is the slotter cutter needed ( width of cut ) and can one be found to fit the framon to do the job first off.
Observations on keys blade and cuts from tip to bow the cuts are not side by side they overlap each other in places
so getting the spacing correct will be important and time consuming.
The cuts at first glance look Very small but on further inspection slots cuts are wider than first thought as they overlap .
Possible around 0.75 inch wide or there abouts
There is a good possibility of locking key in A clamp on the 10 mil above the actual cuts which are 16.3 mil approximately.
And key blade is around 30mm in total length from tip up to the plastic head.
Ringo